Industrial

Hydraulic manifold production

Precision-machined hydraulic manifolds with internal passages and pressure ports.

Image
Sector

Industrial

Annual volume

3,200 units

Material

6061-T6

Quality

CMM + pressure testing

Program start

Q1 2025

Vector Motion

Four-axis machining

Deep-hole drilling

Thread machining

Pressure testing

Internal geometry that couldn't be inspected the usual way

A manifold program required complex internal passages, threaded ports, and controlled pressure interfaces that couldn't be verified with a standard CMM touch-probe routine the critical features were internal and largely inaccessible once the part was machined. Early parts had passed external dimensional checks but failed pressure testing downstream, well after the part was considered complete.

MachiniX restructured the process around verification points built into the machining sequence itself, rather than treating pressure testing as a final, separate step. Internal passages were bored and inspected via bore-scope and air-decay testing at defined stages, catching a blocked or undersized passage before the part moved to threading and final assembly.

Threaded ports were held to a controlled thread-gauge routine at each port individually, since a single out-of-spec port could compromise the pressure interface for the entire manifold regardless of how the rest of the part measured.

01) In-process verification

Bore-scope and air-decay checks at defined machining stages catch internal passage defects before the part reaches final pressure testing.

02) Port-by-port control

Every threaded port is gauge-checked individually, since one out-of-spec port can compromise the pressure interface even when the rest of the manifold is in spec.

03) Reduced late-stage failures

Moving verification earlier in the sequence catches defects before threading and assembly, instead of after the part is considered complete.

04) Pressure-interface reliability

The finished process ties machining, in-process inspection, and pressure testing together, rather than treating pressure testing as a final independent check.

18%

Reduction in machining time

3.5 days

Average production lead time

100%

Pressure-tested production partsPressure-tested production parts

Create a free website with Framer, the website builder loved by startups, designers and agencies.